Proper installation of Bimetal Cylinder Liner is essential to ensure the performance of the engine and extend its service life. Here are the detailed installation steps:

1. Preparation

Clean: Thoroughly clean the engine block to ensure that there are no impurities, oil and old sealant remaining in the block.

Check: Confirm that the size of Bimetal Cylinder Liner matches the engine, and check whether there is damage or defect on the cylinder liner surface to ensure that its quality is intact.

Second, the installation process

Initial placement: Gently place the Bimetal Cylinder Liner into the mounting hole of the cylinder block, with special care to avoid collision and scratching.

Press into the cylinder liner: Using a special installation tool or press, the cylinder liner is slowly and evenly pressed into the cylinder block to ensure that its installation position is accurate.

Calibrate verticality: During installation, use tools such as a square to periodically check the verticality of the cylinder liner to ensure that it is installed vertically.

Check flatness: When the cylinder liner is fully installed in place, carefully check whether the joint surface of the cylinder liner and the cylinder body is smooth. If it is uneven, it needs to be properly trimmed to ensure a good contact surface.

Iii. Follow-up treatment

When installing the piston and piston ring, apply an appropriate amount of lubricating oil to ensure smooth movement of the piston.

When installing the cylinder head and other components, tighten the bolts according to the specified torque to avoid too tight or too loose.

After the installation is completed, the engine is run in, during which the working state of the engine should be observed. If there is any abnormality, check and deal with it in time.

By following the above steps, the wear resistance and tightness of the engine can be effectively improved, thus extending its service life.